1. Shut off the hot and cold-water supply valves.

2. Remove the existing supply lines from the washing machine.

3. Screw the SafeSupply-FreezeGuards onto the supply valves.

4. Attach the water supply lines to the
    SafeSupply-FreezeGuards and tighten them using a wrench.

5. Screw on the push-to-connect elbows. Tighten them with a 13mm         wrench, being careful not to overtighten.

6. Ensure knurled thumb screw is closed.

7. Insert one end of the clear tubing into the push-to-connect elbow.

8. Turn on the hot and cold-water supply valves and thoroughly                 check for any leaks.

9. Adjust the knurled thumb screw to start a micro-drip through the           clear tubing. Aim for a rate of one drip every two seconds.

10. Place the remaining end of the clear tube securely into the                    standing drainpipe.